Member Sites  ::  JOIN  ::  Forum  ::  Info  ::  Next Ring  
#1 Free Wallpaper, Backgrounds, Web Graphics - Spruce up your desktop or web page with free graphics! 1000's of free backgrounds, icons, wallpaper, animated gifs, line

  Forums     Login   Signup



#1 Free Wallpaper, Backgrounds, Web Graphics

Manager: bluepossum
A forum for anything general audience friendly that might help with graphic creation; backgrounds, wallpaper, gifs, jpegs, lines, buttons, etc.
 

Sponsored Links

Come visit the forum
If you have ideas and imagery.....
  "If you have ideas and imagery, technique will follow." Unknown

Picasso......
  Picasso was in a park when a woman approached him and asked him to draw a p

One must seek solutions......
  "One must seek solutions that are engaging and demanding visually." Unk
read...
Forum Posts - Start a new discussion! Posts 1 - 1 of 1
All Threads |   All Posts   ]

Tutorial for 3D Modelling a Mobile Phone - 02/11/2013
http://2.bp.blogspot.com/_7o8SdS3qwN4/S6Tev_iIZAI/AAAAAAAAAwg/GDQohTol7Bs/s1600-h/3d_wireframe_character.jpg

Step 1: From Create, Geometry create a Box with the Length of 10.8cm, the Width of 5.4cm and the Height of 0.35cm. After that convert the Box to Editable Poly by right clicking on the screen and selecting Convert to> Convert to Editable Poly. Note: Press "V" to switch between viewports. Step 2: In the Modify tab select the Edge selection mode and select the top 2 edges. Click the box next to chamfer, change the chamfer amount to 1.3 and the Segments to 24. Click OK. Step 3: Now select the bottom edge and chamfer them with an amount of 2.3 and 36 Segments. Step 4: Go to Polygons selection mode, select the front polygon and Bevel it with a Height of 0.35cm an the Outline of -0.2cm. Note: Press F3 to turn On/Off the Wireframe View Toggle. Press F4 View Edge Faces Toggle. Step 5: Go back to Edge selection mode and make a ring selection of the edges you see below. Select only one edge and click on Ring. Connect the with 1 segment and a Slide of 70. Step 6: Now select the edge resulted from connect and Chamfer it with 2 Segments and 0.025cm amount. Note: Press Alt+X to see trough. Step 7: Select one edge and click on Ring to make a ring selection. Now hold down CTRL and click on the Polygons icon to convert the selection. Step 8: With the polygons resulted from converting the edges selected, Inset them with an amount of 0.01cm. Step 9: Extrude the polygons with an amount of -0.025cm and change the Type to Local Normal. After that delete the polygons by pressing Delete on your keyb...

Tutorial for 3D Modelling a Mobile Phone



All Threads |   All Posts   ]





Contact Us | Copyright © 2001-2016 WebRing®, Inc. Terms of Service - Help - Privacy Policy